Caricamento
Lumeitalia
What MINI FLOOR INOX 316L is, which outdoor architectural and in-ground lighting projects it fits, which regulatory requirements to verify and how to specify it.
MINI FLOOR INOX 316L — Mini in-ground luminaires Ø42-Ø110 mm, 1-3 W, stainless steel or copper cover. MINI FLOOR is the series of mini in-ground luminaires with 316L stainless steel cover, from Ø42 to Ø110 mm. 1 W models (Ø42, Ø52, Ø62) and 3 W models (Ø73, Ø92, Ø110), 12V, 24V or 220V power supply. Flat, domed, stainless steel or copper cover; narrow beam versions for vertical grazing light on walls and columns. This Centro Studi briefing does not replace the product page: it frames the luminaire within the design process, from requirement definition to on-site verification.
MINI FLOOR INOX 316L belongs to the outdoor architectural and in-ground lighting scope and is used in pedestrian paths, squares, façades, gardens and water features. Three items always come first: classification of the scope under the applicable standard, the real installation geometry (spacings, heights, brackets or pitches) and the maintenance conditions planned over the installation life cycle.
Photometric data: Specific photometric values (flux, efficacy, expected illuminance) are not published in generic form because they depend on configuration and installation geometry. Photometric files for calculation are available from the technical office at info@lumeitalia.it.
The requirement must be stated before product selection and repeated at commissioning with the same measurement method. A requirement written without a reference standard and without verification conditions is the most frequent cause of dispute at acceptance.
During installation the main variables are aiming, tightening of the fixings and correct execution of the electrical terminations. In operation, the maintenance plan must state the cleaning frequency of the optical surfaces, periodic gasket checks and how electronic components are replaced.
MINI FLOOR INOX 316L is a defensible choice when outdoor architectural and in-ground lighting requirements are stated, the calculation reproduces the real geometry and commissioning follows an agreed protocol. The full datasheet and quotation request are on the product page: https://lumeitalia.it/prodotti/mini-floor-inox. The technical office is available for design requirement reviews at info@lumeitalia.it.
Outdoor architectural and in-ground lighting projects covering pedestrian paths, squares, façades, gardens and water features. Suitability starts from scope classification and real geometry, not from datasheet comparison.
Photometric files for the proposed luminaires, declaration of conformity, declared lifetime data per IES LM-80 with its conditions, maintenance schedule and warranty terms.
It depends on the inherited geometry: existing spacings and heights must be checked with a dedicated calculation before confirming a one-for-one replacement. The technical office runs the check on request.
Because an out-of-context figure cannot be verified: the result depends on configuration, optic and installation geometry. Photometric files are available at info@lumeitalia.it.