Lumeitalia
Centro Studi note on recurring requests and points of attention in car park and parking area lighting projects in 2026.
This note collects the operational updates that the Lumeitalia technical office flags to designers in 2026 for car park and parking area lighting interventions. Surface and multi-storey car parks run for long hours, which makes them prime candidates for energy retrofits.
The regulatory reference for car park and parking area lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
The most frequent request is no longer only energy saving but demonstrability of the result: a documented baseline, an agreed verification protocol and exportable operating data have become recurring items in specifications. This change rewards projects built on written requirements and penalises supplies described by brand.
In car park and parking area lighting projects the three points on which the technical office intervenes most often remain the maintenance factor, consistency between photometric file and supplied luminaire, and the definition of control system behaviour under degraded conditions. They are also the three points generating most non-conformities at commissioning.
Centro Studi Lumeitalia publishes operational guides, methodological comparisons and updated technical deep dives; the technical office is available to review requirements, specifications and verification protocols. Requests can be addressed to the contacts published in the site's contact section.
The difficulties that most often emerge in car park and parking area lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A car park and parking area lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
Usually not: a reduced maintenance level with presence-triggered boost balances savings, safety and CCTV requirements.
Covered car parks are treated as indoor spaces under EN 12464-1, plus the emergency lighting requirements of EN 1838.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.