Lumeitalia
Quality parameters often missing from specifications and how to state them verifiably for car park and parking area lighting.
Two installations meeting the same quantitative requirements can produce very different perceptions. Surface and multi-storey car parks run for long hours, which makes them prime candidates for energy retrofits. This deep dive covers the light-quality parameters that affect comfort and visual performance in car park and parking area lighting, and that rarely appear in tender documents.
The regulatory reference for car park and parking area lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
The general colour rendering index describes average fidelity over a limited sample set and does not tell the whole story: the TM-30 method introduces fidelity and gamut indices that better describe behaviour on saturated colours. Where colour recognition is functional — safety, quality control, video capture — specifying only the general value can lead to unsatisfactory results even with formally met requirements.
Residual flux modulation is a safety parameter, not only a comfort one: with moving parts, the stroboscopic effect can alter the perception of rotation speed. Specifications should require the manufacturer's declared flicker metrics also under dimming, because many systems get worse precisely at low dimming levels, where the installation spends most of its time.
Discomfort glare is assessed with the indices set by the applicable standard, but perception also depends on factors the calculation does not capture: background contrast, prevailing viewing direction, reflective surfaces. In car park and parking area lighting it is worth identifying critical viewing positions at design stage and checking them explicitly, rather than relying on the area average alone.
Colour stability over time and between luminaires completes the picture: visible differences between adjacent fittings are perceived as a defect even when each individual luminaire meets its declared tolerances.
The difficulties that most often emerge in car park and parking area lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A car park and parking area lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
Usually not: a reduced maintenance level with presence-triggered boost balances savings, safety and CCTV requirements.
Covered car parks are treated as indoor spaces under EN 12464-1, plus the emergency lighting requirements of EN 1838.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.
