Lumeitalia
What THOR INOX is, which tunnel lighting projects it fits, which regulatory requirements to verify and how to specify it.
THOR INOX — Acciaio inox per ambienti corrosivi. Versione in acciaio inox AISI 316L per gallerie marittime, tunnel sottomarini e ambienti con atmosfera corrosiva. Resistenza estrema alla corrosione. This Centro Studi briefing does not replace the product page: it frames the luminaire within the design process, from requirement definition to on-site verification.
THOR INOX belongs to the tunnel lighting scope and is used in road tunnels, underpasses and covered cuttings. Three items always come first: classification of the scope under the applicable standard, the real installation geometry (spacings, heights, brackets or pitches) and the maintenance conditions planned over the installation life cycle.
Photometric data: Specific photometric values (flux, efficacy, expected illuminance) are not published in generic form because they depend on configuration and installation geometry. Photometric files for calculation are available from the technical office at info@lumeitalia.it.
The requirement must be stated before product selection and repeated at commissioning with the same measurement method. A requirement written without a reference standard and without verification conditions is the most frequent cause of dispute at acceptance.
During installation the main variables are aiming, tightening of the fixings and correct execution of the electrical terminations. In operation, the maintenance plan must state the cleaning frequency of the optical surfaces, periodic gasket checks and how electronic components are replaced.
Declared marks and ratings for the range: ENEC, CE, IP66, IK08. The related documents are supplied with the order confirmation.
THOR INOX is a defensible choice when tunnel lighting requirements are stated, the calculation reproduces the real geometry and commissioning follows an agreed protocol. The full datasheet and quotation request are on the product page: https://lumeitalia.it/prodotti/thor-inox. The technical office is available for design requirement reviews at info@lumeitalia.it.
Tunnel lighting projects covering road tunnels, underpasses and covered cuttings. Suitability starts from scope classification and real geometry, not from datasheet comparison.
Photometric files for the proposed luminaires, declaration of conformity, declared lifetime data per IES LM-80 with its conditions, maintenance schedule and warranty terms.
It depends on the inherited geometry: existing spacings and heights must be checked with a dedicated calculation before confirming a one-for-one replacement. The technical office runs the check on request.
Because an out-of-context figure cannot be verified: the result depends on configuration, optic and installation geometry. Photometric files are available at info@lumeitalia.it.
