Lumeitalia
Method, tools and priorities in lighting design for car park and parking area lighting, in Q&A format.
Conversation with the Centro Studi Lumeitalia technical desk on design method. Surface and multi-storey car parks run for long hours, which makes them prime candidates for energy retrofits. The answers concern working method, not specific products.
The regulatory reference for car park and parking area lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
From a page of written requirements. It sounds trivial, but the difference between a project that holds and one that generates variations is almost always there: what the installation must do, under which conditions, how it is verified. The calculation software comes later and does not replace this stage.
Less than people think, if the requirements are right; a great deal, if the previous stage went wrong. A well-chosen luminaire on wrong requirements produces an installation that does not serve its purpose. We prefer to spend time verifying assumptions rather than comparing datasheets.
In car park and parking area lighting the recurring difficulty is covering wide surfaces with acceptable uniformity and few light points. It is not solved with installed power but with distribution and verification of real operating conditions. When it is addressed during the survey stage, the rest of the project flows.
Three pieces of information: who will use the space and for which activities, who will maintain the installation and how often, and which constraints are non-negotiable. With these three answers the design is set correctly; without them, work proceeds on implicit assumptions that surface once the works are finished.
The difficulties that most often emerge in car park and parking area lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A car park and parking area lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
Usually not: a reduced maintenance level with presence-triggered boost balances savings, safety and CCTV requirements.
Covered car parks are treated as indoor spaces under EN 12464-1, plus the emergency lighting requirements of EN 1838.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.
