Lumeitalia
The relationship between performance standards and regional light-pollution rules in car park and parking area lighting projects.
Light-pollution requirements are set at regional level and coexist with national and European performance standards. Surface and multi-storey car parks run for long hours, which makes them prime candidates for energy retrofits. This analysis clarifies how to manage the overlap in car park and parking area lighting projects without sacrificing safety requirements.
The regulatory reference for car park and parking area lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
Technical standards define performance requirements; regional regulations set limits on upward light emission, luminaire aiming and in some cases operating hours. These are not alternative rules: the design must satisfy both at once. Where they appear incompatible, the problem is almost always in the chosen installation solution, not in the requirements.
Control of upward light output is achieved with suitable optics and correct luminaire aiming, not by indiscriminately reducing levels. In car park and parking area lighting the most common mistake is compensating for unsuitable optics by increasing installed power: the result is an installation that consumes more, spills more and remains non-uniform anyway.
Time-based dimming, where allowed, is the most effective tool to reduce night-time impact while keeping performance in the hours when it is needed. Profiles must be documented in the design and verified at commissioning, otherwise they remain a never-activated function.
The design report should contain a dedicated section citing the applicable regulation, listing the controlled parameters and comparing design values with limits. This short section prevents additional requests during permitting and provides the basis for any later checks.
The difficulties that most often emerge in car park and parking area lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A car park and parking area lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
Usually not: a reduced maintenance level with presence-triggered boost balances savings, safety and CCTV requirements.
Covered car parks are treated as indoor spaces under EN 12464-1, plus the emergency lighting requirements of EN 1838.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.
