Lumeitalia
Which quantities to monitor, how to use them and how to avoid dashboards full of useless data in road tunnel lighting.
Collecting data is easy; using them to make decisions is the real problem. In a road tunnel lighting installation, a few well-chosen quantities produce more value than an overloaded dashboard. In tunnels, lighting is a safety system: it must support the eye's adaptation between outdoor and indoor luminance, by day and by night.
The regulatory reference for road tunnel lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
The essential operational information is light-point status, consumption per zone, burning hours and anomaly alarms. Everything else is useful only if someone uses it for a recurring decision. Before adding a sensor, ask which action will change based on the data it produces.
An effective dashboard does not show everything: it shows what requires action. Faults to repair, zones with abnormal consumption, points approaching the scheduled-maintenance threshold. The rest should be archived and queryable, not displayed on the front page.
Where the system collects data relating to people or vehicles, data-protection compliance must be assessed from the design stage, defining purpose, legal basis and retention periods.
Value increases when lighting data talk to other systems of the organisation: maintenance management, energy accounting, citizen reporting. Integration, however, requires documented, stable interfaces, to be specified in the tender rather than negotiated after installation.
The difficulties that most often emerge in road tunnel lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A road tunnel lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
The average luminance of the driver's field of view at one stopping distance from the portal, measured in a 20° cone: it is the input for sizing the threshold zone.
No. At night the adaptation step is much smaller, so only permanent lighting stays in service, usually at reduced levels.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.
