Lumeitalia
How to write a performance specification for car park and parking area lighting avoiding ambiguous clauses and unverifiable requirements.
A well-written specification is worth as much as a good design: it defines what is being bought, how it will be verified and who is liable if the result does not arrive. In car park and parking area lighting projects most disputes come from generic clauses or requirements nobody knows how to measure. Surface and multi-storey car parks run for long hours, which makes them prime candidates for energy retrofits.
The regulatory reference for car park and parking area lighting is not a single document but a coordinated set of standards covering performance, safety and environmental impact. In design practice the following documents drive the main choices.
A performance specification describes the required result and the conditions of verification; a descriptive one lists product features. The former leaves room for different but equivalent solutions, the latter risks restricting competition without guaranteeing performance. In practice both are needed: performance-based for lighting requirements, descriptive for durability, maintainability and compatibility with the existing installation.
Each requirement should answer three questions: what value is required, which standard defines it, and how it will be verified. If one is missing, the clause will produce divergent interpretations. It helps to state accepted tolerances and the moment of verification explicitly: at handover, after the stabilisation period, or at deferred commissioning.
In this specific case, the key requirements to state cover the lighting performance required by the applicable standard, the technical documentation to be delivered (calculations, photometric files, declarations of conformity, maintenance manuals) and warranty conditions, specifying scope and duration.
The specification must state how equivalence of an alternative solution is demonstrated: which documents are needed, who assesses them and against which criteria. Without clear rules, variant assessment becomes discretionary and slows the procedure. A table matching requirements to supporting documents solves most of the problem.
The difficulties that most often emerge in car park and parking area lighting projects are not about product selection, but about defining requirements and verifying results.
An orderly method drastically reduces variations during works and disputes at commissioning. Three choices make the difference from the earliest stages.
Non-conformities found at commissioning almost always come from three causes: requirements not declared or declared without a reference standard, calculation run on idealised geometry, and an optimistic maintenance factor. All three can be avoided at zero cost during design.
A car park and parking area lighting project holds up over time when requirements are declared, the calculation reproduces real conditions and on-site verification follows an agreed protocol. Component selection matters, but comes later: without measurable requirements even the best product delivers a result that cannot be demonstrated. Centro Studi Lumeitalia makes its technical office available to review requirements and design checks.
Methodological note: This content is written for technical information purposes by Centro Studi Lumeitalia and does not replace the lighting design or a full reading of the standards cited. Applicable performance values are those of the standards in force at design time.
Usually not: a reduced maintenance level with presence-triggered boost balances savings, safety and CCTV requirements.
Covered car parks are treated as indoor spaces under EN 12464-1, plus the emergency lighting requirements of EN 1838.
From a written definition of performance requirements and verification conditions: this step drives every later choice and makes the result either disputable or defensible at commissioning.
Photometric files of the proposed luminaires, declaration of conformity, lifetime data declared per IES LM-80 with its conditions, the maintenance schedule and warranty terms.
